If you want to Jailbreak your iPod, then you need to know the method the enable dfu mode iPod touch. Although the process is simple, but it is lengthy, and you need to pay minute attention on the time as well. So, make sure you read and understand this document completely before starting this process, and you move ahead only if you understand its.

Connect with the computer: To enable the device firmware upgrade mode for your iPod touch first you need to connect it to your computer. Make sure you connect it using USB cable and when you plug it then iTunes is running on your computer.

Turn off the iPod: Now you need to power off your iPod Touch. Press the power button and hold it until you see a slider to shut down the device. Slide it and wait until your device is completely turned off. Make sure you continue only after it is powered off completely.

[embedyt] http://www.youtube.com/watch?v=0TIiAB_cNPA[/embedyt]

Start the device: This is a crucial step so pay minute attention to time. Press the power button and hold it for three seconds. After that press the home button and hold it for 10 seconds and do not leave the power button during this process. After holding both the buttons for exactly 10 seconds, release the power button but keep holding the home button. Now your device screen will remain blank, but on iTunes, you will get a message that a device has been detected. In some cases, you may need to repeat this method tow or three times to success.

Now you enabled the dfu mode iPod touch, and you can make the changes that you want to do. If you want to jailbreak the device you can take next step accordingly and if you want to place it into recovery mode, then you have options for that as well. So, choose an option carefully, and you get will get the desired output easily with this method.

LEAVE A REPLY

Please enter your comment!
Please enter your name here